Σε αυτόν τον οδηγό, Θα αποσυναρμολογήσω ένα Asus G75VX.
Make sure the laptop is turned off before you start taking it apart.
Πώς να αποσυναρμολογήσετε το Asus N71JQ:
Σταυρό κατσαβίδι, a rigid card
Αφαιρέστε το 2 βιδώστε όπως σημειώνεται παρακάτω και ανοίξτε το 2 κάτω κάλυμμα (Δ πλευρά)
![]()
Αφαιρέστε το 2 nets which are used to keep out insects.

Αφαιρέστε τις βίδες.
Though there are three different size marked A/B/B, One screwdriver is enough.

Υπάρχουν 2 memory slots in D side, in fact, another two is from the inside.


Remove the screw marked in the below picture.
After that, we can remove the optical drive as the shown direction.



After removing the screw, take out the 2 hard drive bays and the hard drives as below pictures.


D side is disassembled.
Now we need to separate AB side from CD side
First remove the 2 screws besides and the 3 screws in the battery
compartment


Then put it upright, remove the baffle booth of the revolving axis as below picture from side. Be careful with the connection cable with the speaker and the motherboard.
Unplug the white connector directly and don’t break the cable.


This is the revolving axis
cover with two speakers


|
|
|
|
|
|
|
After removing the optical drive, there are another 3 βίδες (B size) to be removed.
Remove all the screws as marked below
3 on the cover of D side
2 around the subwoofer
2 in the battery compartment
They’re all A size

Γύρισέ το, remove 6 screws on the revolving axis
Place the laptop as the picture shows, separate the C and D side.
Start from the market place, use a rigid card to separate the slot of C side from the button sideways.
Open C side slowly, αφαιρέστε το 5 ribbon wires from up. Follow the direction of the wires, it can be easily opened.
- white cable connect the touchpad buttons
- white cable connect the touchpad
- keyboard cable
- keypad light cable
- switch buttons cable
You are able to change wifi network card and the original memory by now.
If you want to clean the dust, then go on.
Pay attention to the marked position.
The red outline——3D glass receiver
The blue outline——camera
The red oval——screen panel line connector
The blue oval——wifi network card cable
The wlan card antenna needs to be removed.

Remove the marked screw, then the screen can be removed.
We can separate the motherboard from D side now.
Αφαιρώ 6 screws attached to the fan.
And if you want to clean the fan separately, you need to unplug the power interface marked with red oval and take out the black strip seal on both sides, then you can remove the fan.
The upper blue oval——USB3.0 port
The lower blue oval——audio board port
The blue outline——subwoofer port
The red outline——sata and motherboard port
There is only one screw securing the audio board and it doesn’t need to be removed
picture of audio board

Picture of graphics card
Picture of revolving axis
sata port module
Subwoofer
heat dissipation

|
|
|
|